Best 60 Gallon Kobalt Air Compressor
Best results for 60 gallon kobalt air compressor
Powermate Vx 072-0020RP Tank Drain Valve
VH901800AV Campbell Hausfeld Air Compressor Air Filter
NEW 3.7HP COMPRESSOR DUTY ELECTRIC MOTOR, 56 FRAME, 3450 RPM, 5/8" SHAFT DIAMETER, NEMA RATED MOTOR, REPLACES 5HP SPL MOTORS RATED 15-17AMPS
$208.99
$307.22
Amazon.com
Last update was on: November 24, 2024 6:43 am
- NEW 3.7HP COMPRESSOR DUTY MOTOR, SINGLE PHASE, 56 FRAME, 3450RPM, 5/8" SHAFT DIAMETER
- IF THE MOTOR YOU ARE REPLACING SHOWS HP AS (5HP SPL) OR JUST (SPL) AND IS ALSO RATED BETWEEN 15-17 FULL LOAD AMPS AT 230V, THIS MOTOR WILL REPLACE YOURS
- CCW (COUNTER CLOCKWISE) SHAFT ROTATION WHEN VIEWED FROM THE SHAFT END. SHAFT ROTATION IN NOT REVERSIBLE
- 2.25" SHAFT LENGTH, KEYED SHAFT, 60HZ, 1.0 SERVICE FACTOR
Interstate Pneumatics SA142 1/2" MPT Compressor Air Filter Replacement – Paper Cartridge + Small Metal Body replaces Campbell Hausfeld p/n HL018200AV
PneumaticPlus SAW400-N04BG-MEP Compressed Air Filter Regulator Piggyback Combo 1/2" NPT – Metal Bowl, Manual Drain, Bracket, Gauge
Campbell Hausfeld CV223300AV Check Valve Large Port
3.7 HP 3450 RPM, 56 Frame, 230V, 17.2Amp, 5/8" Shaft, Single Phase NEMA Air Compressor Motor – EM-04
Powermate Vx 094-0137RP Vibration Isolator
$7.85
$9.97
Amazon.com
Last update was on: November 24, 2024 6:43 am
- 4-Inch by 4-Inch by 1/2-Inch
- For use with stationary units
- A Powermate vibration isolator can also help prevent wear and tear to the compressor and air hoses caused by intense vibration of unit during use
- Powemate vibration isolators curb the noise and vibration produced by large stationary compressors
Campbell-Hausfeld CW209300AV Pressure Switch for Air Compressors
Crankcase Breather Vh3000 Pump
5 HP SPL Compressor Motor Electric 56 Frame Single Phase 3455 rpm, 5/8" Shaft
B&M 70266 SuperCooler Automatic Transmission Cooler
$121.95
$171.95
Amazon.com
Last update was on: November 24, 2024 6:43 am
- Rigid stacked-plate design is resistant to damage, and much better at cooling than ordinary 'fin and tube' coolers
- Constructed from black finished lightweight aluminum alloy for maximum corrosion resistance
- 11" x 8" x 1-1/2" racing model is rated at 20,500 BTU, and pressure tested to 200 PSI
- Fluxless, oven brazed construction is vibration resistant
- Multiple oil flow paths for maximum cooling efficiency
